Any equipment needs to be cleaned and maintained during use, and packaging machine products are no exception. Regular maintenance and cleaning are essential work. Specifically, the main parts that need to be cleaned are the sliding plate, left knife, right knife, and middle knife. However, how to operate them during the cleaning and maintenance process? Below, Aixun will provide you with a detailed introduction:
① Skateboard: (as shown in the figure) The skateboard must have a precise fit with the left and right guide rails, and must maintain smooth and free movement in front of the skateboard. Therefore, this area needs to be cleaned and maintained most. The cleaning process is summarized as follows:
a. Remove the tension spring below the skateboard.
b. Move the skateboard back and remove it.
c. Clean the grooves between the skateboard and the left and right guide rails.
d. Install the packaging machine slide plate between the left and right guide rails and pull on the spring.
e. Move the skateboard back and forth to see if it is smooth. If adjustment is needed, the right guide rail cannot be moved, just adjust the left guide rail.
f. Add a small amount of needle turning oil or lighter lubricating oil between the sliding plate and the left and right guide rails.
g. If the skateboard can move freely but still cannot return to its original position: check if the tension spring is tired, and if so, replace or shorten it.
The above is the cleaning and maintenance work of the packer's slide plate that ixun summarized for you based on previous work experience. In future articles, ixun will share the cleaning and maintenance work of other parts of the packer in turn. You are welcome to continue to follow the official website of Qingdao ixun or the official Tiktok account of Qingdao ixun Yupack
