Strapping machine conveyor is actually divided into two steps, the first step is the storage tape. The so-called storage belt is the process in which the packing machine takes the packing belt off the tape tray and puts it into the storage box. The second step is the tape. It is the process of sending the packing tape inside the storage box to the belt slot. Many people can't tell the difference between these two steps, in fact, the performance of frequent belt delivery is mostly the process of baling the belt has been stored, and today Ai Xun will share with you the reason:
1. The door of the storage box is not closed. The belt storage box has a small door near the movement, which is used to wear the belt. After the completion of the belt wearing, the operator often forgets to close the door, so that the belt storage box has been unable to store the belt, which causes the baler to send the belt all the time.
2. The storage sensor is faulty. There is a sensor at the bottom of the storage box, its role is to detect whether the packing belt is full, if the sensor fails, then the baler will continue to work.
3. strap feeding is not in place. This conveyor belt is not in place means that the packing belt is not sent to the position of the movement, but rushed out of the packing belt slot, in this case, the baler will not stop working, will always send the belt, can not stop.
After reading the above introduction, do you have a clear understanding of the frequent delivery of balers? For more troubleshooting methods of baling machine, please continue to pay attention to Qingdao Yupack official website www.yupack.cn or Yupoack official Douyin account: Yupack.